1. Low Temperature Soldering: 
High Power / mass ration tips and integrated 
heater / thermocouple delivers the best thermal 
recovery in the market along with lower soldering 
temperatures.
2. Read & Feed:
We use one wire buried deep in the tip of the 
copper to “read & feed.” Our thermocouple 
and heating element are one in the same and 
are microprocessor driven over a sensor at 60 
hertz (60x a second) utilizing up to 140 watt 
transformer. This is why our thermal performance 
cannot be matched.
3. Initial Heat Up:
A conventional station takes between 10 to 90 
seconds to reach 360° C. Any JBC station with 
a T210 hand piece reaches this temperature in 
only two seconds.
4. Outstanding Tip Life:
Lasting up to five times longer as soon as 
the soldering iron is left in the stand, the tip 
temperature automatically drops to 200° C, 
decreasing oxidation and wear. Resulting in a 
working life three to five times longer than that 
of the conventional tip. When the soldering iron 
is taken out of the stand again, the working 
temperature is instantaneously reached. 
NOTE: It varies by tip geometry, temperature 
settings, solder, flux, and the person using it; 
However generally, it ranges between 25,000 
and 100,000 solder joints.
5. Quick Change Over Tips:
No tools needed to change the tip. Just place in 
holder, pull and insert the new tip. Reduces your 
idle time while increasing operator safety.
6. Ergonomic Design:
The JBC soldering iron are currently the lightest, 
smallest and most ergonomic hand piece 
available. Offering the shortest tip to hand 
distance and a higher working performance.
7. Process Control:
Regain control of your process! Set temperatures 
limits, read counters, block the station with PIN 
or block the keypad.
8. Intelligent Heat Management:
Extend tip life by reducing temperature and 
reduce energy usage to 10 watts during sleep 
and 4 watts when hibernating.
9. Easy Calibration:
Since JBC technology is microprocessor driven, 
it not necessary to recalibrate any of the JBC 
stations but, if required, calibration of the 
soldering tip can easily be done by using TI 2800 
Thermometer and the temperature adjustment 
featured in the station’s menu.
10. Improved Productivity:
The JBC technology gives an 80% improvement 
over the performance of the best soldering 
station available in the market. In the following 
graphs, based on practical test, we show this 
superiority.